Polaris 165
SKU #6-120-00
Powered by the pressure of clean water returning to the pool, the 165 uses a patented jet sweep assembly that blows water against the pool wall to loosen debris in hard-to-reach places even if the pool has an uneven bottom. Its easy-to-remove filter bag captures debris before it reaches your pump basket or filter.
Designed for any Vinyl or Fiberglass In-Ground Pools
- The Polaris Vac-Sweep 165 is designed for any vinyl or fiberglass in-ground pool, even those with an uneven bottom up to eight feet deep.
- Installs in minutes. Operates with pumps and filtration systems normally found on in-ground pools. Vacuums the bottom and sweeps the sides in three hours or less.
- Patented jet sweep assembly blows water against the pool wall to loosen debris in hard-to-reach places and then sweeps it into an easy-to-remove filter bag.
- Powered by the pressure of clean water returning to your pool, leaving both the filter and skimmer free to eliminate contaminants.
- Unique filter bag removes debris before it reaches your pump basket or filter, prolonging the life of your filtration system.
Specifications
Frequently asked questions
1. Verify that the bag has been installed correctly.
2. Check for air bubbles around the jet body assembly. This may indicate air in the plumbing lines.
3. Ensure the jets are spraying evenly.
4. Verify that the water pressure is between 5 and 10 psi.
Note: The cleaner is operating too fast if the sweep hose and bag are not in contact with the pool bottom a majority of the time and the surface module changes directions more frequently than every 15 to 25 seconds. In this case, unscrew the pressure relief valve until the surface module slows down.
